ASTM A478-2019 pdf free download

ASTM A478-2019 pdf free download.Standard Specification for Chromium-Nickel Stainless Steel Weaving and Knitting Wire
1. Scope
1.1 This specification covers the more commonly used types of round stainless steel wire intended especially for weaving and knitting. 1.2 The values stated in inch-pound units are to be regarded as the standard. 1.3 This international standard was developed in accor- dance with internationally recognized principles on standard- ization established in the Decision on Principles for the Development of International Standards, Guides and Recom- mendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
2. Referenced Documents
2.1 ASTM Standards: 2 A555/A555M Specification for General Requirements for Stainless Steel Wire and Wire Rods A751 Test Methods, Practices, and Terminology for Chemi- cal Analysis of Steel Products
3. Ordering Information
3.1 It is the responsibility of the purchaser to specify all requirements that are necessary for material ordered under this specification. Such requirements may include, but are not limited to, the following: 3.1.1 Quantity (weight), 3.1.2 Name of material (stainless steel), 3.1.3 Condition (see Section 5), 3.1.4 Finish (see Section 7), 3.1.5 Cross section (round), 3.1.6 Form (wire), 3.1.7 Applicable dimensions (diameter), 3.1.8 Type designation (see Table 1), 3.1.9 ASTM designation and date of issue, and 3.1.10 Special requirements. 3.2 If possible, the intended end use of the item should be given on the purchase order especially when the item is ordered for a specific end use or uses. N OTE 1—A typical ordering description is as follows: 1000 lb; stainless steel, dead soft, bright annealed wire, 0.015 in. diameter, spools, Type 304, ASTM Specification A478 dated ______, End Use Wire Screen.
4. Chemical Composition
4.1 The steel shall conform to the requirements as to chemical composition specified in Table 1. 4.2 Methods and practices relating to chemical analysis required by this specification shall be in accordance with Test Methods, Practices, and Terminology A751.
5. Conditions
5.1 Wire may be furnished in one of the following condi- tions: 5.1.1 Annealed, 5.1.2 Bright annealed, or 5.1.3 Cold drawn.
6. Mechanical Requirements
6.1 The material shall conform to the requirements as to mechanical properties specified in Table 2.
7. Finish
7.1 The types of finish procurable are as follows: 7.1.1 Pickled finish and 7.1.2 Bright finish.
8. General Requirements for Delivery
8.1 In addition to the requirements of this specification, all requirements of the current edition of Specification A555/ A555M shall apply. Failure to comply with the general requirements of Specification A555/A555M constitutes non- conformance with this specification.